Single Sided Lamination ( Craft Paper Method ) - GBC F - 160 Operation And Maintenance Manual

F - 160 Operation and Maintenance Manual
d) Press STOP.
00.0
S P E E D
S A F E T Y
e) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
f) Remove the roll of laminate from the upper
unwind shaft and remove the release liner from
the rewind tube.
g) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
0
J O B
End of application
© GBC Pro - Tech August 1999
F W R
G O
R E V .
S T O P
S A V
S E L
S H U T D O W N
6.4 Single sided lamination
( Craft paper method )
This application may be performed from the
front of the laminator using the main rollers or from the
rear of the laminator using the pull rollers in the event
the main rollers are heated. This application is explained
in detail using the main rollers from the front of the
laminator. Use Chart 4 and Diagram 4 for assistance.
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
Materials needed
• Roll of pressure sensitive over laminate
• Roll of craft paper ( same width as the laminate )
• Print ( smaller than the laminate )
• Roll of masking tape
• Utility knife
• Cutting blade with an enclosed casing.
• Piece of cardboard ( film width x 6 in. )
Set up
a) Turn MAIN POWER to "ON". Refer to
Figure 6.4.1
Applications
WARNING
Page 6 - 25