Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
Keep hands and fingers clear of the pull
roller nip when changing the gap.
You can be CRUSHED!
p) Once the cardboard has passed through the pull
rollers, lower the upper pull roller onto the web.
Turn the pull roll crank handle 3/4 turn
clockwise after you feel the initial contact. Refer
to Figure 6.4.6
INFORMATION
PRESSURE will vary with the thickness
and width of the laminate you are using.
Adjust as necessary.
q) Cut the cardboard from the webbed material.
Refer to Figure 6.4.6
Do not use an open blade to cut
the web near the rollers.
You can put cuts into the rollers!
r) Tape the web to the lower rewind tube or let the
web run out to a work table. Refer to Figure
6.4.6
© GBC Pro - Tech August 1999
WARNING
CAUTION
INFORMATION
If you choose to use the lower rewind tube,
make note of the direction of travel.
Figure 6.4.6 Finish product rewind
Cut the piece
of cardboard
off
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
- Press on the variable speed footswitch to
lengthen the web enough to get one full wrap
around the lower rewind tube.
Applications
Finished
product
rewind
WARNING
Page 6 - 31
Advertisement
Table of Contents
