GBC F - 160 Operation And Maintenance Manual page 181

Applications
k) Tape the web to the lower rewind tube or let
the web run out to a work table. Refer to
Figure 6.9.5
INFORMATION
If you choose to use the lower rewind tube,
make note of the direction of travel.
Figure 6.9.5 Finish product rewind
Cut the piece
of cardboard
off
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
Page 6 - 92
Finished
product
rewind
WARNING
F - 160 Operation and Maintenance Manual
- Press on the variable speed footswitch to
lengthen the web enough to get one full wrap
around the lower rewind tube.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
l) Replace the front infeed table. Ensure that the
table is seated properly.
m) Close the front and rear safety shields.
INFORMATION
The SAFETY indicator should not be
flashing when the tables are properly
seated and the safety shields are in
the closed position..
n) Press STOP.
00.0
S P E E D
S A F E T Y
© GBC Pro - Tech August 1999
CAUTION
F W R
G O
R E V .
S T O P