GBC F - 160 Operation And Maintenance Manual page 83

Operations
c) Raise the front safety shield.
d) Press SEL.
0
J O B
Flashing
e) Position the leader board in the center of the
main rollers between the nip.
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
Page 5 - 18
S E L S A V
S H U T D O W N
=
CAUTION
WARNING
F - 160 Operation and Maintenance Manual
f) At eye level with the main rollers, press
PRESSURE until you see the upper main
roller make contact with the substrate.
G A P
0
Excess pressure can damage the laminating
rollers. Always use the minimum roll
pressure necessary to complete the task.
INFORMATION
Excessive pressure will cause the
substrate to bow or flatten.
INFORMATION
Density of the substrate will determine the
amount of pressure you may use.
INFORMATION
Refer to Figure 5.5.1 for proper roller
pressure.
© GBC Pro - Tech August 1999
P R E S S U R E
CAUTION