Table of Contents
Advertisement
Trailer board
Image
Release liner
Pre-coated baord
Release liner from PSA film
Image
Kraft
Paper
Option
42
Mount
Adhesive
Leader board
Boards
Fig. 34
Fig. 35
Thermal
or PSA
Film
Roll to roll option
Fig. 36
APPLICATIONS
TIPS FOR PRE COATING BOARDS
(Figure 34)
1. Load the laminator as illustrated
in Figure 34. Remove chill idler.
2. The width of the roll should not
exceed the width of the board
by more than 1/2 in. (1.3 cm).
3. Use a leader board to set the
main roller and pull roller
pressure prior to webbing.
4. Use a leader board to start the
run and a trailer board to finish
the run.
5. Using the pull rollers will allow
you to leave gaps between
boards.
6. If not using the pull rollers, have
the boards nearby to butt end to
end during feeding.
TIPS FOR MOUNTING PRE-
COATED BOARDS (Figure 35)
1. This application can also be
performed from the rear
operating position. Reference
Figure 38 for illustration.
2. Use a leader board to set the
main roller pressure prior to
mounting the image.
3. Ensure the chill idler is removed
and the rear slitter is to one side.
4. Heat, 125
O
F (52
the process and increase output
quality.
5. Do not stop once you have
started the mounting process
through the machine.
TIPS FOR SINGLE SIDED
LAMINATION (Figure 36)
1. Load the laminator as illustrated
in Figure 36.
2. Use kraft paper for one-sided
lamination whenever the items to
be laminated are narrower than
the film you are using.
Output
3. If not using kraft paper, use a
scrap piece to finish the run or
you will have adhesive on your
rollers.
4. For high volume runs, use Kraft
paper and the lower rear rewind
for roll to roll operation.
5. Running the web over the chill
idler may improve the flatness of
the output.
6. A little heat, 125
help eliminate silvering effects
associated with PSA films.
Preliminary
Copy
O
C), may assist
O
O
F (52
C), may
I
Advertisement
Table of Contents
