Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
b) Raise the pull roller up by turning the crank
handle counter clockwise until the pull rollers
are separated.
c) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
d) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
0
J O B
End of application
© GBC Pro - Tech August 1999
S A V
S E L
S H U T D O W N
Group 3 : Top / bottom heat
Group three contains applications requiring heat
to activate the upper and lower materials.
The procedures and its parameters
described in this section are starting references
only. Parameters will vary with regards to laminate
thickness, laminate widths, laminates types, print
types, ink or toner types, enviroment conditions,
operator experience and various substrates.
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
6.9 Encapsulation
This application can only be performed from the
front of the laminator using the main rollers. This
application is explained in detail using the main rollers at
the front operating position of the laminator. Use Chart
11 and Diagram 11 for assistance.
Applications
WARNING
Page 6 - 85
Advertisement
Table of Contents
