Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
d) Since the safety shields are raised and the
tables removed, you must use the footswitch to
rotate the bottom rollers after cleaning a
section.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
Method 2
a) Allow the laminator to cool slightly to no
o
higher than 110
S L E E P
T O P T E M P .
< 1 1 0
b) Set the motion direction to REV
00.0
S P E E D
S A F E T Y
© GBC Pro - Tech August 1999
CAUTION
o
F ( 43
C ).
B O T . T E M P
< 1 1 0
.
F W R
G O
R E V .
S T O P
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
b) Set the nip of the rollers to the thickness of the
adhesive coated boards.
G A P
1/4
WARNING
Keep hands and fingers clear of
the laminator roller nip when
adjusting PRESSURE.
You can be CRUSHED or BURNED!
c) Using the variable speed footswitch, run
the adhesive coated boards through the rolls.
d) Do this as many times as needed to clean the
laminator rolls.
Maintenance
P R E S S U R E
Page 8 - 5
Advertisement
Table of Contents
