Table of Contents
Advertisement
Applications
Excess pressure can damage the laminating
rollers. Always use the minimum roll
pressure necessary to complete the task.
INFORMATION
Excessive pressure will cause the
substrate to bow or flatten.
j) Press STOP.
00.0
S P E E D
S A F E T Y
k) Press REV
to reverse the direction of the
motor.
00.0
S P E E D
S A F E T Y
Page 6 - 12
CAUTION
F W R
G O
R E V .
S T O P
F W R
G O
R E V .
S T O P
F - 160 Operation and Maintenance Manual
When operating the laminator through the
variable speed footswitch, keep your hands
away from the nip of the rollers. You may
be crushed or burned.
l) Press on the variable speed footswitch to back
the board out of the main rollers.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
Process
a) Align the leading edge of the image with the
leading edge of the precoated board and one
other side. Refer to Figure 6.2.2
Figure 6.2.2 Align edges
Align two
sides
© GBC Pro - Tech August 1999
WARNING
CAUTION
Leading
edge
Pre-coated
board
Advertisement
Table of Contents
