GBC F - 160 Operation And Maintenance Manual page 141

Applications
INFORMATION
The two pieces cut in step "a" will be
used as the leader board and trailer
board. These two pieces can be saved
and reused for other applications.
c) Turn MAIN POWER to "ON". Refer to
Figure 6.6.1
d) Press RESET. Refer to Figure 6.6.1
e) Be sure the front and rear tables are in position
and the pull rollers are in the up position.
f) Raise the rear safety shield.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
Page 6 - 52
WARNING
F - 160 Operation and Maintenance Manual
Figure 6.6.1 MAIN POWER / RESET
g) Lift the clevis pin located in the saddle of the
upper unwind shaft.
Saddle
h) Swing the upper unwind shaft out enough to
slide the roll of Hot Tissue over the core chucks
and onto the upper unwind shaft. Refer
to Figure 6.6.2.
INFORMATION
Twisting the roll of Hot Tissue while
sliding makes loading the film onto
the unwind shaft easier.
© GBC Pro - Tech August 1999
R E S E T
M A I N P O W E R
Clevis pin