GBC F - 160 Operation And Maintenance Manual page 103

Applications
d) From the center, use one finger to tack down
the leading edge of the image to the leading
edge of the precoated board. Refer to Figure
6.2.6
INFORMATION
The leading edge is the first part of the
board or image that enters the nip
of the rollers.
Figure 6.2.6 Tack leading edge
INFORMATION
Avoid tacking at the ends first and pressing
towards the center, you may create a tunnel
once you have reached the center. This will
make for a difficult mounting application.
e) Set the precoated board with the image tacked
to it in the center of the front infeed table.
Page 6 - 14
F - 160 Operation and Maintenance Manual
f) Press STOP.
00.0
S P E E D
S A F E T Y
g) Press FWD .
00.0
S P E E D
S A F E T Y
h) Push the leading edge of the precoated board
up to the nip of the main rolls.
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
i) Using the variable speed footswitch, slowly
work the precoated board into the nip of the
rollers. Stop just before the end of the tacked
down section of the image enters the nip.
© GBC Pro - Tech August 1999
F W R
G O
R E V .
S T O P
F W R
G O
R E V .
S T O P
WARNING