Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
INFORMATION
Use a slow speed. If the tack point enters
the rollers nip, you will not be able to
pull the release liner.
- If the tack point enters the rollers nip perform
the following steps then continue with this
procedure.
1) Press STOP
2) Press REV
3) Press on the variable speed
footswitch to back the tack point
out of the rollers nip.
4) Press STOP
5) Press FWD
6) Continue from step i).
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
j) Drape the loose part of the image over the
upper main roller. Refer to Figure 6.2.7
© GBC Pro - Tech August 1999
CAUTION
Figure 6.2.7 Draping the image
Upper
Main
Roll
Pre-coated board
k) Make sure the image is conformed to the upper
main roller. Refer to Figure 6.2.8
INFORMATION
If the image is not conformed to the roller,
you may experience difficulties with
this application.
Figure 6.2.8 Conformed print
Upper
Main
Roll
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
Applications
Image
Release liner
Conformed
WARNING
Page 6 - 15
Advertisement
Table of Contents
