Table of Contents
Advertisement
Applications
i) Press on the variable speed footswitch to back
the leader board out of the main rollers.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
Process
a) Align the leading edge of the image with the
leading edge of the board and one other side.
Refer to Figure 6.5.7
Figure 6.5.7 Align edges
Align two
sides
INFORMATION
The leading edge is the first part of the
board or image that enters the nip
of the rollers.
Page 6 - 46
CAUTION
Leading
e d g e
Substrate
F - 160 Operation and Maintenance Manual
b) Is the decal compatible with the substrate?
- If the substrate is larger than the decal, you
can position the image any where on the board.
Figure 6.5.8
Figure 6.5.8 Setting the decal
- You must trim the decal so that no more than
1 in. exceeds the size of the substrate. Refer to
Figure 6.5.9
Figure 6.5.9 Trim the decal
Image
Board
No more than 1 in. over hang
© GBC Pro - Tech August 1999
Cut
Advertisement
Table of Contents
