Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
Figure 6.1.2 Unwind shaft
Saddle
Core support
Brake adjust
knob
i) Once loaded, swing the upper unwind shaft back
into the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
j) Push the clevis pin back down to secure the
unwind shaft in its saddle.
k) Raise the front safety shield.
© GBC Pro - Tech August 1999
Clevis pin
Roll of
adhesive
Core chucks
CAUTION
WARNING
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
INFORMATION
If you have the parameters stored as a
JOB number enter it now then press
SEL and skip to step " o ", other wise
continue with step " l".
l) Press SEL. SEL will stop flashing.
S E L
0
J O B
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
Y o u c a n C R U S H E D o r B U R N E D !
Applications
S A V
S H U T D O W N
Page 6 - 3
Advertisement
Table of Contents
