Table of Contents
Advertisement
Installation
c) Remove all packing materials to a safe distance
from the laminator and dispose of properly.
d) Use two people to carefully roll the laminator to
the desired location.
INFORMATION
About recycling: The crate components can
be reused for shipping the laminator again
or can be disassembled and the wood and
screws recycled. The shrink wrap is not
recyclable, so it must be discarded.
4.5 Accessory pack
Once the Falcon 160 Laminator has been
unpacked and moved into final position, open the
accessory pack and verify the contents.
Accessory Pack contents
• One T-handle allen wrench ( 475-200 )
• One Zippy knife ( 475-620 )
• One Terry clothe towel ( 475-950 )
• One Operators manual ( 930-031 )
• One roll masking tape ( 475-000 )
• Two Polyurethane O-rings ( 480-005 )
• One strain relief for main power ( 175-201 )
• One rubber cement pad ( 930320 )
• One crankhandle ( 629-018 )
• One fuse, 0.5A ( 186-022 )
• Two fuses, 2.5A ( 186-220 )
Page 4 - 8
F - 160 Operation and Maintenance Manual
If you are missing any of the itemslisted above,
contact your local service technician or sales
representative.
4.6 Leveling
Leveling of the laminator is very important in the
way the machine performs. Leveling is crucial to the
tram ( tracking ) of the materials through the machine.
INFORMATION
Improper leveling, will result in poor
output quality.
Tools required
• Torpedo level
• ( 2 ) 3/4" open end wrenches
• Four leveling pads
( from the accessory pack )
• Second person
Preparation
a) Verify that the laminator has sufficient room
around it to load film, walk around and
serviced if necessary.
© GBC Pro - Tech August 1999
Advertisement
Table of Contents
