GBC F - 160 Operation And Maintenance Manual page 115

Applications
b) Press RESET. Refer to Figure 6.4.1
Figure 6.4.1 MAIN POWER / RESET
c) Ensure that the front and rear tables are in
position and the rear pull rollers are in the up
position..
d) Raise the rear safety shield.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
Page 6 - 26
RESET
M A I N P O W E R
WARNING
F - 160 Operation and Maintenance Manual
e) Lift the clevis pin located in the saddle of the
upper unwind shaft.
S a d d l e
f) Swing the upper unwind shaft out enough to
slide the roll of laminate over the core chucks
on the upper unwind shaft. Refer to Figure
6.3.2
INFORMATION
Twisting the roll of laminate while sliding
makes loading the film onto the unwind
shaft easier.
Figure 6.3.2 Unwind shaft
Saddle
Core support
Brake adjust
knob
© GBC Pro - Tech August 1999
Clevis pin
Clevis pin
Roll of
laminate
Core chucks