GBC F - 160 Operation And Maintenance Manual page 117

Applications
Process
a) Apply just enough brake tension to prevent the
roll of laminate from free spinning.
INFORMATION
Excessive brake tension may cause the
image to curl when separated from
the craft paper.
b) Pull the laminate to the upper rewind tube.
Refer to Figure 6.4.3
Make note of the rewind tube drive
direction when taping the laminate.
The laminate should separate under
the rewind tube.
Figure 6.4.3 Laminate to rewind
P.S.A.
Laminate
Page 6 - 28
CAUTION
Rewind
tube
F - 160 Operation and Maintenance Manual
c) Use a piece of masking tape, to adhere the
leading edge of the laminate to the upper rewind
tube.
d) Wrap one full turn of laminate onto the upper
rewind tube.
Do not cut too deeply into the laminate, you
can cut into the release liner.
e) With the utility knife, make an incision across
the width of the laminate.
CAUTION
Caution should always be exercised
when using a knife .
Sharp knife can cut you!
f) Remove the front infeed table.
g) Pull the laminate straight down toward the front
of the lower main roller. Refer to Figure 6.4.4
© GBC Pro - Tech August 1999
CAUTION