GBC F - 160 Operation And Maintenance Manual page 151

Applications
Figure 6.7.1 MAIN POWER / RESET
g) Lift the clevis pin located in the saddle of the
upper unwind shaft.
Saddle
h) Swing the upper unwind shaft out enough to
slide the roll of thermal laminate over the core
chucks and onto the upper unwind shaft. Refer
to Figure 6.7.2.
INFORMATION
Twisting the roll of thermal laminate
while sliding makes loading the film
onto the unwind shaft easier.
Page 6 - 62
F - 160 Operation and Maintenance Manual
Figure 6.7.2 Unwind shaft
R E S E T
Core support
M A I N P O W E R
Brake adjust
i) Once loaded, swing the upper unwind shaft back
Clevis pin
j) Push the clevis pin back down to secure the
k) Lower the rear safety shield.
Saddle
knob
into the saddle.
CAUTION
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
unwind shaft in its saddle.
© GBC Pro - Tech August 1999
Clevis pin
Roll of
Thermal
laminate
Core chucks