GBC F - 160 Operation And Maintenance Manual page 183

Applications
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
e) Raise the pull roller up by turning the crank
handle counter clockwise until the pull rollers
are separated.
f) Remove the front infeed table.
g) Cut the web of thermal laminates at the upper
and lower unwind shafts with an enclosed
blade.
h) Remove the web from the front of the laminator
and the rolls of material from the upper and
lower unwind shafts.
INFORMATION
This will prevent any exposed adhesive from
contacting the rollers.
i) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
Page 6 - 94
WARNING
F - 160 Operation and Maintenance Manual
j) Replace the front infeed table.
k) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
0
J O B
End of application
6.10 Charts and Diagrams
Use the parameter charts and web up diagrams
can to assist you with the applications described. It is
recommended that you keep these parameter charts
and web up diagrams in the manual for reference. Make
copies if you require them in other locations.
Use the blank parameter chart and blank web
up diagram to record specific applications not illustrated
in this section. For converting degrees Fahrenheit to
degrees Celsius, refer to Figure 6.10.1
Parameters will vary with regards to
laminate thickness, laminate widths, laminates
types, print types, ink or toner types, enviroment
conditions, operater experience, and various
substrates.
© GBC Pro - Tech August 1999
S E L S A V
S H U T D O W N