Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
b) Is the decal compatible with the substrate?
- If the substrate is larger than the decal, you
can position the image any where on the board.
Refer to Figure 6.8.7
Figure 6.8.7 Setting the decal
- You must trim the decal so that no more than
1 in. exceeds the size of the substrate. Refer to
Figure 6.8.8
Figure 6.8.8 Trim the decal
Image
Board
No more than 1 in. over hang
© GBC Pro - Tech August 1999
Cut
c) Peel back about 1 in. of the release liner from
the decal and fold back. Refer to Figure
6.8.9
Figure 6.8.9 Peel back release liner
Leading edge
d) Place a padded paper weight or similar object
in the center. This will help hold the image in
place.
e) From the center, use one finger to tack down
the leading edge of the decal to the leading
edge of the substrate. Refer to Figure 6.8.10
Figure 6.8.10 Tack leading edge
Applications
Release liner
Back of Image
Page 6 - 81
Advertisement
Table of Contents
