GBC F - 160 Operation And Maintenance Manual page 125

Applications
Figure 6.5.2 Unwind shaft
Saddle
Core support
Brake adjust
knob
g) Once the roll of laminate is on the upper unwind
shaft, swing the upper unwind shaft back into
the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
h) Push the clevis pin back down to secure the
unwind shaft in its saddle.
i) Leave the safety shield in the up position.
Page 6 - 36
Clevis pin
Roll of
laminate
Core chucks
CAUTION
F - 160 Operation and Maintenance Manual
j) Lift the clevis pin located in the saddle of the
lower unwind shaft.
S a d d l e
k) Swing the lower unwind shaft out enough to
slide the roll of mount adhesive over the core
chucks on the lower unwind shaft. Refer to
Figure 6.5.2
INFORMATION
Twisting the roll of mount adhesive
while sliding makes loading the film
onto the unwind shaft easier.
l) Once the roll of mount adhesive is on the lower
unwind shaft, swing the lower unwind shaft
back into the saddle.
CAUTION
Ensure the roll of mount adhesive is
loaded properly on the unwind shaft.
Exposed adhesive should be
facing away from the rollers.
This will prevent hours of roll cleaning!
© GBC Pro - Tech August 1999
Clevis pin