Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
g) Once the roll of laminate is on the upper unwind
shaft, swing the upper unwind shaft back into
the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
h) Push the clevis pin back down to secure the
unwind shaft in its saddle.
i) Leave the safety shield in the up position.
j) Lift the clevis pin located in the saddle of the
lower unwind shaft.
S a d d l e
k) Swing the lower unwind shaft out enough to
slide the roll of craft paper over the core chucks
on the lower unwind shaft. Refer to Figure
6.4.2
© GBC Pro - Tech August 1999
CAUTION
Clevis pin
INFORMATION
Twisting the roll of craft paper while
sliding makes loading the film onto
the unwind shaft easier.
l) Once the roll of craft paper is on the lower
unwind shaft, swing the lower unwind shaft
back into the saddle.
INFORMATION
The roll of craft paper has no preference to
side since both sides are the same.
m) Push the clevis pin back down to secure the
unwind shaft in its saddle.
n) Center the upper roll and the lower roll of
material on the unwind shafts. You may refer to
your measurement chart in Section 5.3.2
Loading film ( Figure 5.3.4 )
INFORMATION
For the lower unwind shaft, add 1/4 in. to
the measurement.
Applications
Page 6 - 27
Advertisement
Table of Contents
