Table of Contents
Advertisement
Applications
Pass 1: Decal
Use Chart 9 and Diagram 9 for assistance.
Materials needed
• Roll of thermal laminate
• Roll of mount adhesive ( same width as the
laminate )
• Print ( smaller than the laminate )
• Roll of masking tape
• Utility knife
• Cutting blade with an enclosed casing.
• Piece of cardboard ( film width x 6" )
Set up
a) Turn MAIN POWER to "ON". Refer to
Figure 6.8.1
b) Press RESET. Refer to Figure 6.8.1
Figure 6.8.1 MAIN POWER / RESET
Page 6 - 70
F - 160 Operation and Maintenance Manual
You can be seriously HURT or INJURED!
Saddle
RESET
M A I N P O W E R
c) Ensure that the rear pull rollers are in the up
position..
d) Raise the front and rear safety shields.
WARNING
Caution should always be exercised
when using the laminator with
the safety shields raised.
e) Lift the clevis pin located in the saddle of the
upper unwind shaft.
f) Swing the upper unwind shaft out enough to
slide the roll of laminate over the core chucks
on the upper unwind shaft. Refer to Figure
6.8.2
© GBC Pro - Tech August 1999
Clevis pin
Advertisement
Table of Contents
