Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
y) After the last print has passed through the pull
rollers, press STOP.
9.0
S P E E D
S A F E T Y
z) Press GAP
to a 1 in. setting.
G A P
1
Finishing
a) With an enclosed blade, cut the finished product
from the web.
Do not use an open blade to cut
the web near the rollers.
You can put cuts into the rollers!
b) The prints are now ready to be trimmed.
When trimmed, the craft paper will fall away
from the back of the print.
© GBC Pro - Tech August 1999
F W R
G O
R E V .
S T O P
P R E S S U R E
CAUTION
c) If you used the lower rewind, remove the
rewind tube and bring it to a trimming station.
Replace the rewind tube when finished.
d) Raise the front and rear safety shields to the up
position.
WARNING
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
e) Raise the pull roller up by turning the crank
handle counter clockwise until the pull rollers
are separated.
f) Remove the front infeed table.
g) Cut the web of laminate and craft paper at the
upper and lower unwind shafts with an enclosed
blade.
CAUTION
Do not use an open blade to cut
the web near the rollers.
You can put cuts into the rollers!
Applications
Page 6 - 33
Advertisement
Table of Contents
