Table of Contents
Advertisement
Safety
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
INFORMATION
For the lower unwind shaft, add 1/4 in. to
the measurement.
INFORMATION
When requiring top and bottom heat, it is
recommended to set both temperatures to
the same set point.
INFORMATION
Do not add PRESSURE when heating the
laminating rollers, this allows the high
release silicone to expand with minimum
restrictions.
Page 1 - 10
CAUTION
F - 160 Operation and Maintenance Manual
INFORMATION
Slow speed will assists with heat up times
and distributes heat evenly.
INFORMATION
When the laminator is first turned on, the
front control panel will go into the default
mode.
Default mode; TOP TEMP. = 68
BOT. TEMP. = 68 oF ( 20 oC ), GAP = 1 in.,
PRESSURE = no bars are solid, JOB = 0, no
motion direction selected, SPEED = 00.0 and
SLEEP = flashing
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
INFORMATION
When storing parameters within the JOB
SAVE feature of the laminator, PRESSURE
is not a storable setting.
© GBC Pro - Tech August 1999
o
o
F ( 20
C ),
WARNING
Advertisement
Table of Contents
