GBC F - 160 Operation And Maintenance Manual page 160

F - 160 Operation and Maintenance Manual
INFORMATION
Twisting the roll of laminate while sliding
makes loading the film onto the unwind
shaft easier.
Figure 6.8.2 Unwind shaft
Saddle
Core support
Brake adjust
knob
g) Once the roll of thermal laminate is on the upper
unwind shaft, swing the upper unwind shaft
back into the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
© GBC Pro - Tech August 1999
Clevis pin
Roll of
laminate
Core chucks
CAUTION
h) Push the clevis pin back down to secure the
unwind shaft in its saddle.
i) Lift the clevis pin located in the saddle of the
lower unwind shaft.
Saddle
j) Swing the lower unwind shaft out enough to
slide the roll of mount adhesive over the core
chucks on the lower unwind shaft. Refer to
Figure 6.8.2
INFORMATION
Twisting the roll of mount adhesive
while sliding makes loading the film
onto the unwind shaft easier.
k) Once the roll of mount adhesive is on the lower
unwind shaft, swing the lower unwind shaft
back into the saddle.
Applications
Clevis pin
Page 6 - 71