Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
Materials needed
• Prints ( Decals )
• Substrates
• Utility knife
• Leader board ( substrate width x 6" )
Set up
a) Replace the front infeed table.
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
b) Position the leader board between the pull
rollers.
Keep hands and fingers clear of the pull
roller nip when changing the gap.
You can be CRUSHED!
© GBC Pro - Tech August 1999
WARNING
WARNING
c) While observing the leader board at eye level,
lower the upper pull roller by turning the pull roll
crank handle clockwise until contact with the
leader board has been made.
CAUTION
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
INFORMATION
If the thickness of the substrate is not
known, follow the procedure to manually
set the nip in Section 5.5.2 Manually nip
adjustment.
CAUTION
Excess pressure can damage the laminating
rollers. Always use the minimum roll
pressure necessary to complete the task.
INFORMATION
Excessive pressure will cause the
substrate to bow or flatten.
Applications
Page 6 - 79
Advertisement
Table of Contents
