Table of Contents
Advertisement
Applications
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
When the laminator rollers are in
motion, keep hands and fingers
away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
o) Use one hand to pull the release liner off as the
substrate moves towards the nip and the other
hand to apply slight back tension to the decal.
p) Once the substrate and the decal are completely
through the main rolls, you can let off the
variable speed footswitch.
q) The mounted image can now be removed from
the rear of the laminator.
r) Trim the mounted piece as necessary.
Page 6 - 50
CAUTION
WARNING
F - 160 Operation and Maintenance Manual
Finishing
a) Press STOP.
9.0
S P E E D
S A F E T Y
b) Press GAP
to a 1 in. setting.
G A P
1
c) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
d) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
0
J O B
End of application
© GBC Pro - Tech August 1999
F W R
G O
R E V .
S T O P
P R E S S U R E
S E L
S A V
S H U T D O W N
Advertisement
Table of Contents
