Installation - GBC F - 160 Operation And Maintenance Manual

Safety
Press RESET located on the left leg at the rear
of the machine.
The front and rear tables must be in proper
position for the laminator to operate under normal
condition. Figure 1.2.5 illustrates the tables and keys.
If these tables are removed, you may operate
the laminator using the variable speed footswitch. The
speed is controlled through a "accelerator pedal" style
footswitch. Please see footswitch in section 3 of this
manual.
Figure 1.2.5 Tables and keys
Page 1 - 4
Reset
F - 160 Operation and Maintenance Manual

1.3 Installation

The following symbols are positioned at
various points in Section 4 Installation.
Failure to follow the pre-installation check
list can result in damage to the laminator.
The operating environment must be free of
dust, flammable liquids and vapors. You can
be injured by inhaling chemical vapors.
Vapor build up or stored flammable liquids
can cause a fire. Excessive dust can damage
the laminator.
Do not locate the laminator where air is
blowing directly on the machine. The air
flow can cool the rolls unevenly and result in
poor quality output.
© GBC Pro - Tech August 1999
CAUTION
WARNING
WARNING
CAUTION