Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
Figure 6.9.2 Unwind shaft
Saddle
Core support
Brake adjust
knob
g) Once the roll of thermal laminate is on the upper
unwind shaft, swing the upper unwind shaft
back into the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
h) Push the clevis pin back down to secure the
unwind shaft in its saddle.
© GBC Pro - Tech August 1999
Clevis pin
Roll of
laminate
Core chucks
CAUTION
i) Lift the clevis pin located in the saddle of the
lower unwind shaft.
Saddle
j) Swing the lower unwind shaft out enough to
slide the roll of thermal laminate over the core
chucks on the lower unwind shaft. Refer to
Figure 6.9.2
INFORMATION
Twisting the roll of thermal laminate
while sliding makes loading the film
onto the unwind shaft easier.
k) Once the roll of thermal laminate is on the
lower unwind shaft, swing the lower unwind
shaft back into the saddle.
l) Push the clevis pin back down to secure the
unwind shaft in its saddle.
Applications
Clevis pin
Page 6 - 87
Advertisement
Table of Contents
