Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
INFORMATION
Excessive pressure will cause the
substrate to bow or flatten.
w) Press STOP.
00.0
S P E E D
S A F E T Y
x) Press REV
to reverse the direction of the
motor.
00.0
S P E E D
S A F E T Y
When operating the laminator through the
variable speed footswitch, keep your hands
away from the nip of the rollers. You may
be crushed or burned.
© GBC Pro - Tech August 1999
F W R
G O
R E V .
S T O P
F W R
G O
R E V .
S T O P
WARNING
y) Press on the variable speed footswitch to back
the board out of the main rollers.
CAUTION
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
Process
INFORMATION
If you are using precoated Hot Tissue
boards, proceed to step " d )".
a) Cut a sheet of Hot Tissue the same size as the
image. Refer to Figure 6.7.3
b) Run a thin line of glue across the leading edge of
the substrate. Refer to Figure 6.7.3
INFORMATION
The leading edge is the first part of the
board or image that enters the nip
of the rollers.
Applications
Page 6 - 65
Advertisement
Table of Contents
