GBC F - 160 Operation And Maintenance Manual page 112

F - 160 Operation and Maintenance Manual
INFORMATION
Steps " i" and " j" will be performed
simultaneously.
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
i) Push the leader board into the main roller nip
while stepping on the variable speed footswitch.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
j) Apply the minimum amount of brake tension on
the roll of laminate to prevent it from free
spinning. Refer to Figure 6.3.5
INFORMATION
Excessive brake tension may cause the
image to curl when separated from the
precoated board.
© GBC Pro - Tech August 1999
WARNING
CAUTION
Figure 6.3.5 Separation point
Separation
point
k) Once you have the brake tension set and the
laminate looks smooth entering the main roller,
release the variable speed footswitch.
l) Now lay the image to be laminated on the
precoated board.
INFORMATION
The laminate will not adhere to the release
liner of the precoated board which makes
the board reusable.
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
Applications
Laminate
WARNING
Page 6 - 23