Job Programming - GBC F - 160 Operation And Maintenance Manual

F - 160 Operation and Maintenance Manual
f) Press SEL to engage the parameters.
0
J O B
g) Press GO to engage the motor drive system.
2.0
S P E E D
S A F E T Y
h) When the rollers are close to it's set point value,
the temperature displays stop flashing,
pressSTOP and raise the gap to 1 in. by
pressing GAP
G A P
1
© GBC Pro - Tech August 1999
S E L S A V
S H U T D O W N
F W R
G O
R E V .
S T O P
P R E S S U R E

5.4 Job programming

The job save feature is very convenient if the
same parameters are required to perform various
applications. This procedure will guide you step by step
through this feature.
a) Follow the prcedure in Section 5.3.1 Power.
INFORMATION
When the laminator is first turned on, the
front control panel will go into the default
mode.
Default mode; TOP TEMP. = 68
BOT. TEMP. = 68 oF ( 20 oC ), GAP = 1 in.,
PRESSURE = no bars are solid, JOB = 0, no
motion direction selected, SPEED = 00.0 and
SLEEP = flashing
b) Press JOB to enter the desired job number
for the parameters you require to be stored.
1
J O B
Operations
o o
F ( 20 C ),
S E L S A V
S H U T D O W N
Page 5 - 15