GBC F - 160 Operation And Maintenance Manual page 113

Applications
m) Press on the variable speed footswitch.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
When the laminator rollers are in
motion, keep hands and fingers
away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
n) Once the image passes through the main rollers,
it is safe to release the variable speed
footswitch.
INFORMATION
Stopping the rollers on the print will leave a
pressure line on the image.
Page 6 - 24
CAUTION
WARNING
F - 160 Operation and Maintenance Manual
Finishing
a) Cut the web of laminate at the upper unwind
shaft with an enclosed blade.
Do not use an open blade to cut the web
near the rollers. You can put irreparable
cuts into the rollers.
b) Raise the main rolls to a 1 in. gap by pressing
GAP .
G A P
1
c) Pull the material out the front of the laminator.
INFORMATION
This will prevent any exposed adhesive from
contacting the rollers.
© GBC Pro - Tech August 1999
CAUTION
P R E S S U R E