Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
Moving the laminator
a) Have the laminator rolled off the skid and
placed on the floor by licensed riggers. The
ramps included with the laminator can be
secured utilizing screws removed from the
disassembled crate. Figure 4.4.2 illustrates
positioning of the ramps.
Do not attempt to move the laminator across
anything other than a flat level surface
without trained and qualified riggers. You
can be crushed or seriously injured.
Figure 4.4.2 Positioning of the ramps
Do not attempt to use the ramps if they are
not secured to the pallet. Make sure you
have the pallet on a flat even surface before
attempting to roll the machine off using the
ramps.
© GBC Pro - Tech August 1999
WARNING
WARNING
WARNING
The Falcon 160 Laminator is a large and
heavy piece of equipment. It is necessary to
e m p l o y L I C E N S E D R I G G E R S O N L Y t o
move the laminator. The laminator is not
designed to be tipped up or sideways in any
way. Such action disturbs the exact
alignment of the rolling parts of the machine
and requires extensive realignment. You can
be crushed or seriously injured.
INFORMATION
GBC Pro-Tech's warranty does not cover
malfunction of the equipment due to
mishandling and / or tipping. GBC Pro-
Tech bears no responsibility for personal
injury or damage due to moving the
laminator improperly.
b) Remove any plastic strapping and/or packing
paper taped to the rolls.
CAUTION
Do not use a knife or other sharp object to
remove the shrink wrap from around the
laminator. You can cause irreparable
damage to the rollers.
Installation
Page 4 - 7
Advertisement
Table of Contents
