GBC F - 160 Operation And Maintenance Manual page 127

Applications
e) With the utility knife, make an incision across
the width of the laminate.
Caution should always be exercised
when using a knife .
Sharp knife can cut you!
f) Remove the front infeed table.
g) Pull the laminate straight down toward the front
of the lower main roller. Refer to Figure 6.5.4
Figure 6.5.4 Laminate separation
Remove
h) Apply just enough brake tension to prevent the
roll of mount adhesive from free spinning.
Page 6 - 38
CAUTION
Laminate
F - 160 Operation and Maintenance Manual
INFORMATION
Excessive brake tension may cause the
output to curl. This can create complications
with the second pass of this application.
i) Pull the mount adhesive up towards the upper
main roller and tack it the laminate resting on
the upper main roller. Refer to Figure 6.5.5
INFORMATION
The mount adhesive will adhere to the
exposed adhesive from the laminate.
Figure 6.5.5 Mount adhesive
Laminate
© GBC Pro - Tech August 1999
Mount
adhesive