GBC F - 160 Operation And Maintenance Manual page 156

F - 160 Operation and Maintenance Manual
h) Press FWD .
00.0
S P E E D
S A F E T Y
INFORMATION
Steps " i" and " j" will be performed
simultaneously.
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
i) Push the leader board into the main roller nip
while stepping on the variable speed footswitch.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
© GBC Pro - Tech August 1999
F W R
G O
REV.
S T O P
WARNING
CAUTION
j) Apply the minimum amount of brake tension on
the roll of thermal laminate to prevent it from
free spinning.
INFORMATION
Excessive tension will cause the
substrate to bow.
k) Once tentioned, let off the variable speed
footswitch/
l) Position the board with the glued sheet of Hot
Tissue and image against the leader board.
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
m) using a slow speed, press on the variable speed
footswitch while guiding the board into the main
roller nip.
Applications
Page 6 - 67