Table of Contents
Advertisement
Applications
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
m) Press GAP
to the required gap setting for
the substrate being used. The GAP DISPLAY
should reflect your desired setting.
G A P
1/4
INFORMATION
If the thickness of the substrate is not
known, follow the procedure to manually
set the nip in Section 5.5.1 Manual nip
adjustment.
n) Press FWD
.
00.0
S P E E D
S A F E T Y
Page 6 - 4
CAUTION
P R E S S U R E
F W R
G O
REV.
S T O P
F - 160 Operation and Maintenance Manual
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
o) Press on the variable speed footswitch while
guiding the leader board into the nip to confirm
that the board is secure.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
Keep hands and fingers clear of
the laminator roller nip when
adjusting PRESSURE.
You can be CRUSHED or BURNED!
p) If the board is loose, press PRESSURE
adjust the gap between the main rollers.
G A P
1/4
© GBC Pro - Tech August 1999
WARNING
CAUTION
WARNING
P R E S S U R E
to
Advertisement
Table of Contents
