Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
• Press and hold the variable speed footswitch
down.
• Press and hold GO for 3 -4 seconds before
releasing the variable speed footswitch.
• Release the variable speed footswitch.
• Release GO. GO should be solid.
3. In the event that the safety shield must be raised
while the laminator is running, Perform the following
steps;
INFORMATION
If the variable speed footswitch is not
close to the speed of the control panel,
output quality may be affected by the
speed difference.
To raise the safety shield
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
© GBC Pro - Tech August 1999
WARNING
• Press and hold on the variable speed footswitch.
( approximately 1/2 the travel distance of the
variable speed footswitch )
CAUTION
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
WARNING
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
• Raise the safety shield.
INFORMATION
When a safety shield is raised while pressing
on the variable speed footswitch, the speed
may be faster or slower than the indicated
panel speed.
INFORMATION
When the safety shield is raised, the
laminator will only run while the variable
speed footswitch is depressed.
Operations
Page 5 - 7
Advertisement
Table of Contents
