Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
INFORMATION
Avoid tacking at the ends first and pressing
towards the center, you may create a tunnel
once you have reached the center. This will
make for a difficult mounting application.
INFORMATION
If the board is not squarely positioned,
you may experience difficulties with
this application.
INFORMATION
If the image is not conformed to the roller,
you may experience difficulties with
this application.
INFORMATION
Use a slow speed. If the tack point enters
the rollers nip, you will not be able to
pull the release liner.
© GBC Pro - Tech August 1999
WARNING
Keep hands and fingers clear of the pull
roller nip when changing the gap.
You can be CRUSHED!
INFORMATION
Do not lower the pull roller so that the
substrate is crushed when passing through.
This will prevent the boards from bowing.
CAUTION
Caution should always be exercised when
using a utility knife near the rollers.
You can put cuts into the rollers!
INFORMATION
Stopping the rollers on the print will leave a
pressure line on the image.
Safety
Page 1 - 15
Advertisement
Table of Contents
