GBC F - 160 Operation And Maintenance Manual page 150

F - 160 Operation and Maintenance Manual
• Leader and trailer board
• Roll of thermal laminate
• Glue stick
• Prints
( print that are not heat sensitive )
• Utility knife
• Cutting blade with an enclosed casing.
INFORMATION
The laminate must not exceed 1 in. the
width of the substrate. If it does, you
will experience complications with
this application.
Set up
a) Cut two leader boards 6 inch in length of the
material you are about to precoat.
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
b) Place these two pieces by the laminator for
future use.
© GBC Pro - Tech August 1999
CAUTION
INFORMATION
The two pieces cut in step "a" will be
used as the leader board and trailer
board. These two pieces can be saved
and reused for other applications.
c) Turn MAIN POWER to "ON". Refer to
Figure 6.7.1
d) Press RESET. Refer to Figure 6.7.1
e) Be sure the front and rear tables are in position
and the pull rollers are in the up position.
f) Raise the rear safety shield.
WARNING
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
Applications
Page 6 - 61