GBC F - 160 Operation And Maintenance Manual page 157

Applications
INFORMATION
The heat must penetrate through the
thermal laminate, image, Hot Tissue
and to the board. Dwell time is crucial
for the success of this application.
When the laminator rollers are in
motion, keep hands and fingers
away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
n) Stop the laminator when the trailer board is in
the main roller nip. Refer to Figure 6.7.5
Figure 6.7.5 Trailer board
M o u n t e d
i m a g e
Page 6 - 68
WARNING
Trailer
board
F - 160 Operation and Maintenance Manual
INFORMATION
Stopping the rollers on the print will leave a
pressure line on the image.
o) Raise the main rollers to a 1 in. gap by pressing
GAP .
G A P
1
Finishing
a) Cut the web of thermal laminate at the upper
unwind shaft with an enclosed blade.
Do not use an open blade to cut
the web near the rollers.
You can put cuts into the rollers!
b) Pull the leader board, mounted image and trailer
board out from the front of laminator.
© GBC Pro - Tech August 1999
P R E S S U R E
CAUTION