Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
If you accidentally press SAVE at any time,
the old parameters will be replaced with the
new parameters.
INFORMATION
You should store each job location with its
parameters on the chart provided in
Figure 5.4.1
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
Excess pressure can damage the laminating
rollers. Always use the minimum roll
pressure necessary to complete the task.
INFORMATION
Excessive pressure will cause the
substrate to bow or flatten.
© GBC Pro - Tech August 1999
CAUTION
CAUTION
CAUTION
INFORMATION
Density of the substrate will determine the
amount of pressure you may use.
INFORMATION
If the main laminating rollers are heated,
mounting application may be run from the
rear operating position of the machine.
WARNING
Keep hands and fingers clear of the pull
roller nip when changing the gap.
You can be CRUSHED!
CAUTION
Excess pressure can damage the laminating
rollers. Always use the minimum roll
pressure necessary to complete the task.
INFORMATION
Excessive pressure will cause the
substrate to bow or flatten.
Safety
Page 1 - 11
Advertisement
Table of Contents
