Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
f) Raise the rear safety shield.
g) Position the leader board in the center of the
pull rollers between the nip.
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
Keep hands and fingers clear of the pull
roller nip when changing the gap.
You can be CRUSHED!
g) At eye level with the pull rollers, turn the pull
roll crank handle clockwise until you see the
upper pull roller make contact with the
substrate.
D O W N
© GBC Pro - Tech August 1999
CAUTION
WARNING
CAUTION
Excess pressure can damage the laminating
rollers. Always use the minimum roll
pressure necessary to complete the task.
INFORMATION
Excessive pressure will cause the
substrate to bow or flatten.
INFORMATION
Density of the substrate will determine the
amount of pressure you may use.
INFORMATION
Refer to Figure 5.5.2 for proper roller
pressure.
Operations
Page 5 - 21
Advertisement
Table of Contents
