Table of Contents
Advertisement
F - 160 Operation and Maintenance Manual
s) Press SPEED
2 ft. / min. ( .6 m / min. )
2.0
S P E E D
S A F E T Y
t) Press GAP
to enter a 0 in. gap setting.
G A P
0
u) Press GO.
2.0
S P E E D
S A F E T Y
v) Continue with step "w" when the TOP TEMP
DISPLAY and BOT TEMP DISPLAY stops
flashing.
© GBC Pro - Tech August 1999
to set a motor speed of
F W R
G O
R E V .
S T O P
P R E S S U R E
F W R
G O
R E V .
S T O P
w) Press STOP.
2.0
S P E E D
S A F E T Y
Process
a) Raise the front safety shield and remove the
front infeed table.
b) Apply just enough brake tension to prevent the
roll of thermal laminate from free spinning.
INFORMATION
Excessive brake tension may cause the
output to curl. This can create complications
with the second pass of this application.
c) Pull the thermal laminate straight down toward
the front infeed table so that approximately 6 in.
is resting on the front infeed table. Refer to
Figure 6.9.3
Applications
F W R
G O
R E V .
S T O P
Page 6 - 89
Advertisement
Table of Contents
