GBC F - 160 Operation And Maintenance Manual page 70

F - 160 Operation and Maintenance Manual
( 21 ) SPEED : When pressed, increases the speed
of the laminator in increments of 0.5 ft/min. When
pressed and held, speed will automatically increase by
0.5 ft/min increments until it has reached the maximum
allowed speed of 15 ft/min.
6.5
S P E E D
S A F E T Y
( 22 ) SPEED : When pressed, decreases the speed
of the laminator in increments of 0.5 ft/min. When
pressed and held, speed will automatically decrease by
0.5 ft/min increments until it has reached 0 ft/min.
6.5
S P E E D
S A F E T Y
( 23 ) GO: When pressed, starts the rollers in motion.
GO is solid. This solid indication is referred to as the
"panel mode". If a safety shield is raised during "panel
mode", GO and SAFETY ( refer to ( 27 ) SAFETY
for explanation ) begin flashing enabling "footswitch"
mode. ( refer to ( 28 ) FOOTSWITCH for
explanation )
23
6.5
S P E E D
S A F E T Y
© GBC Pro - Tech August 1999
21
F W R
G O
R E V .
S T O P
F W R
G O
R E V .
S T O P
22
F W R
G O
R E V .
S T O P
( 24 ) STOP : When pressed, stops the rollers and GO
becomes white.
6.5
S P E E D
S A F E T Y
( 25 ) FORWARD : When pressed, signals the
laminator to run in a forward motion and FORWARD
becomes solid.
6.5
S P E E D
S A F E T Y
( 26 ) REVERSE : When pressed, signals the
laminator to run in a reverse motion and REVERSE
becomes solid.
6.5
S P E E D
S A F E T Y
Operations
F W R
G O
R E V .
S T O P
24
25
F W R
G O
R E V .
S T O P
F W R
G O
R E V .
S T O P
26
Page 5 - 5