GBC F - 160 Operation And Maintenance Manual page 91

Applications
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
b) Place these two pieces by the laminator for
future use.
INFORMATION
The two pieces cut in step "a" will be
used as the leader board and trailer
board. These two pieces can be saved
and reused for other applications.
c) Turn MAIN POWER to "ON". Refer to
Figure 6.1.1
d) Press RESET. Refer to Figure 6.1.1
e) Be sure the front and rear tables are in position
and the pull rollers are in the up position.
f) Raise the rear safety shield.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
Page 6 - 2
CAUTION
WARNING
F - 160 Operation and Maintenance Manual
Figure 6.1.1 MAIN POWER / RESET
g) Lift the clevis pin located in the saddle of the
upper unwind shaft.
Saddle
h) Swing the upper unwind shaft out enough to
slide the roll of mount adhesive over the core
chucks and onto the upper unwind shaft. Refer
to Figure 6.1.2.
INFORMATION
Twisting the roll of laminate while sliding
makes loading the film onto the unwind
shaft easier.
© GBC Pro - Tech August 1999
R E S E T
M A I N P O W E R
Clevis pin