GBC F - 160 Operation And Maintenance Manual page 105

Applications
- If it is not, slowly move the board into the nip
until the image is conformed. Refer to
Figure 6.2.9
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
Figure 6.2.9 Non conformed print
Upper
Main
Roll
INFORMATION
Steps " l" and " m " will be performed
simultaneously.
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
Page 6 - 16
CAUTION
Not conformed
WARNING
F - 160 Operation and Maintenance Manual
l) Press down on the variable speed footswitch
just enough to give yourself a comfortable work
speed.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
When the laminator rollers are in
motion, keep hands and fingers
away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
m) Use one hand to pull the release liner off as the
substrate moves towards the nip and the other
hand to apply slight back tension to the decal.
n) Once the board and the image are completely
through the main rolls, let off the variable speed
footswitch.
o) The mounted image can now be removed from
the rear of the laminator.
© GBC Pro - Tech August 1999
CAUTION
WARNING