Mounting Only - GBC F - 160 Operation And Maintenance Manual

Applications

6.2 Mounting only

This application may be performed from the
front of the laminator using the main rollers or from the
rear of the laminator using the pull rollers in the event
the main rollers are heated. This application is explained
in detail using the main rollers from the front of the
laminator. Use Chart 2 and Diagram 2 for assistance.
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
Materials needed
• Prints
• P.S.A. mount boards
• Utility knife
• Leader board
Set up
a) Turn MAIN POWER to "ON". Refer to
Figure 6.2.1
b) Press RESET. Refer to Figure 6.2.1
Page 6 - 10
WARNING
F - 160 Operation and Maintenance Manual
Figure 6.2.1 MAIN POWER / RESET
c) Be sure the front and rear tables are in position
and the rear pull rollers are in the up position.
d) Raise the front and rear safety shields.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
INFORMATION
If you have the parameters stored as a
JOB number enter it now then press
SEL and skip to step " h ", other wise
continue with step " e".
© GBC Pro - Tech August 1999
RESET
M A I N P O W E R
WARNING