Table of Contents
Advertisement
Parameter
stbc-tx-streams
supported-mcs-
set
Usage Guidelines
NOTE: AP configuration settings related to the IEEE 802.11n standard are configurable for W-AP120 series access points, which are
IEEE 802.11n standard compliant devices.
The ht-ssid profile configures the high-throughput SSID. Stations are not allowed to use HT with TKIP standalone
encryption, although TKIP can be provided in mixed-mode BSSIDs that support HT. HT is disabled on a BSSID if
the encryption mode is standalone TKIP or WEP.
You can also use this profile to configure explicit transmit beamforming for W-AP130 series access points. When
this feature is enabled, the AP coordinates the signals sent from each antenna so the signals focus on the receiver,
improving radio range and performance. The W-AP130 series AP can advertise transmit beamforming capabilities in
beacon, probe response and association responses in the HT capabilities IE, then use the compressed or
noncompressed beamforming report from clients to form a steering matrix. The AP ensures that the steering matrix
stays current by updating and recalibrating the steering matrix at regular intervals.
By default, W-AP130 series access points support both compressed and non-compressed steering information from
clients. If you have many clients that can send only non-compressed steering reports, best practices are to retain the
default settings, allowing the AP to support both types of steering reports. If all (or nearly all) of the AP's clients are
capable of sending compressed steering reports, best practices are to disable non-compressed steering in the AP's HT
SSID profile.
De-aggregation of MAC Service Data Units (A-MSDUs) is supported on W-3000 series,W-6000M3, and W-7200
series Dell controllers and the with a maximum frame transmission size of 4k bytes; however, this feature is
always enabled and is not configurable. Aggregation is not currently supported.
Example
The following command configures the maximum size of a received aggregate MDPU to be 8191 bytes for the high-
throughput SSID named "htcorpnet:"
(host) (config) #wlan ht-ssid-profile htcorpnet
max-rx-a-mpdu-size 8191
1496 | wlan ht-ssid-profile
Description
MCS 0-7. Higher MCS values are not supported. (Supported on
the W-AP90 series, W-AP130 series, W-AP68, W-AP175 series
and W-AP105 only. The configured value will be adjusted
based on AP capabilities.)
NOTE: If transmit beamforming is enabled, STBC will be
disabled for disabled for beamformed frames.
Controls the maximum number of spatial streams usable for
STBC transmission. 0 disables STBC transmission, 1 uses STBC
for MCS 0-7. Higher MCS values are not supported. (Supported
on W-AP90 series, W-AP175 series, W-AP130 series and W-
AP105 only. The configured value will be adjusted based on AP
capabilities.)
NOTE: If transmit beamforming is enabled, STBC will be
disabled for disabled for beamformed frames.
Comma-separated list of Modulation Coding Scheme (MCS)
values or ranges of values to be supported on this high-
throughput SSID.
Range
0-1
0-23
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Default
1
0-23
Advertisement
Table of Contents
