Dell PowerConnect W-7200 Series Reference Manual page 1400

show wms rules
show wms rules
config
state
summary
Description
Display the internal state and matching information of rules created using the
command.
Syntax
Parameter
config
state
summary
Usage Guidelines
Issue this command to view existing AP classification rules. AP classification rule configuration is performed only on
a master controller. If AMP is enabled via the mobility-manager command, then processing of the AP classification
rules is disabled on the master controller. A rule is identified by its ASCII character string name (32 characters
maximum). The AP classification rules have one of the following specifications:
SSID of the AP
l
SNR of the AP
l
Discovered-AP-Count or the number of APs that can see the AP
l
Example
The output in the example below shows that although two rules have been defined, neither have been enabled using
the ids ap-rule-matching rule-name <name> command.
(host) (config) #show wms rules summary
1400 | show wms rules
Description
Display the following information for each AP classification rule.
name
l
ids
l
match-ssid
l
min-snr
l
max-snr
l
min-prcnt
l
max-prcnt
l
ssids
l
enabled
l
classify
l
conf-incr
l
flags
l
match-cnt
l
Display the following informatoin for each AP classification rule:
SSID Match Table
l
SSID Exclude Table
l
SNR Table
l
Probe Count Table
l
Display an AP classification rules summary.
ids ap-classification-rule change
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide